Chamberlain Universal Remote 370LM User Manual

Models 370LM/370LMC  
3-Button Security® Mini Remote Control  
OWNER'S MANUAL  
The 370LM/370LMC Series remote control (Security®)  
works only with door openers and light controls having a  
purple “learn” button and a yellow indicator light.  
WARNING  
To prevent possible SERIOUS INJURY or DEATH from a moving  
gate or garage door:  
Programming instructions are described and illustrated  
below. The additional push buttons can also activate other  
315MHz garage door openers and/or light controls.  
(Instructions for programming light products are included  
with those accessories.)  
• ALWAYS keep remote controls out of reach of children. NEVER  
permit children to operate, or play with remote control  
transmitters.  
• Activate gate or door ONLY when it can be seen clearly, is properly  
adjusted, and there are no obstructions to door travel.  
Instructions are Described and Illustrated Below  
• ALWAYS keep gate or garage door in sight until completely closed.  
NEVER permit anyone to cross path of moving gate or door.  
9
1
9
1
7
3
7
5
5
KG  
KG  
Open/Close/Stop Operation  
(Only if you have a Multifunction door control)  
Your Security® remote control can be programmed to operate  
one door using all 3 buttons: the left button will only open the  
door, the middle button will only close the door, and the third  
button will stop the door’s movement. You may set up this  
feature as follows:  
Open  
Close  
Stop  
1. With the door closed, press and hold the  
left remote push button.  
1. Press and release the “learn” button on  
the motor unit. The learn indicator light  
will glow steadily for 30 seconds.  
2. Press and hold the Lock button on the  
door control.  
3. Press and hold the door control push bar.  
2. Within 30 seconds, press and hold the  
button on the hand-held remote.  
When the opener lights flash, release all buttons. Test by  
pressing the left (Open) button on the remote. The door should  
open. Press it again while the door is open and nothing should  
happen. Press the middle (Close) button and the door should  
close. Press the third (Stop) button while the door is moving  
and it should stop immediately.  
3. Release the button when the motor unit  
light blinks. It has learned the code. If  
light bulbs are not installed, two clicks  
will be heard.  
The Remote Control Batteries  
To Erase All Codes From Motor Unit Memory  
WARNING  
To deactivate any unwanted remote, first erase all codes:  
To prevent possible SERIOUS INJURY or DEATH:  
Press and hold the “learn” button on motor unit until the learn  
indicator light goes out (approximately  
6 seconds). All previous codes are now  
erased. Reprogram each remote or keyless  
entry you wish to use.  
• NEVER allow small children near batteries.  
• If battery is swallowed, immediately notify doctor.  
The lithium batteries should  
produce power for up to  
5 years. To replace, pry open  
case as shown. Insert  
To Control the Opener Lights  
With SECURITY® transmitters, a remote push button can  
be programmed to operate the opener lights without opening  
the door.  
batteries positive side up (+).  
Dispose of old batteries  
properly.  
1. With the door closed, press and hold the remote button that  
you want to control the light.  
2. Press and hold the Light button on the door control.  
3. Press and hold the Lock button on the door control.  
4. After the opener lights flash, release all buttons.  
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of  
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing  
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.  
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the fol-  
lowing two conditions: (1) this device may not cause harmful interference, and (2) this device  
must accept any interference received, including interference that may cause undesired operation.  
Test by pressing the remote push button. The opener lights  
should turn on or off but the door should not move.  
© 2006, The Chamberlain Group, Inc.  
All Rights Reserved  
114A3091C  
 

Black Box Computer Accessories NBDEP 12 User Manual
Black Decker Laser Level BDL220S User Manual
Boss Audio Systems Stereo System BV9566BI User Manual
Braun Coffeemaker Tassimo User Manual
Brinkmann Gas Grill Gas Kettle Grill User Manual
Brother Automobile 810MC User Manual
Campbell Hausfeld Music Mixer NB0050 User Manual
Casio PDAs Smartphones Version 320 User Manual
Christie Digital Systems Projector DS+305 User Manual
Cisco Systems Automobile Parts 6500 Series User Manual